A fényképezőknél van valami CIPA standard (DC-002), ami gyönyörűen meghatározza, hogy tesztelés közben 50% legyen vakus felvétel aránya, használni kell a zoomot, stb. ... és ez alapján kell meghatározni, hányat lehet fényképezni az adott géptípussal.
Nagyon egyszerű metódus:
The standard CIPA test procedure is as follows (abbreviated for clarity):
1. Power up the camera, set to default focus and image-quality settings, turn on LCD monitor
2. Wait 30 seconds
3. Take a picture
4. Zoom from wide to tele or tele to wide, as appropriate
5. Turn the flash from off to on, or on to off, as appropriate
6. Make sure LCD is still lit, if it has gone out, turn it back on again
7. Wait until 30 seconds has elapsed from previous shot
8. (If 10 minutes has elapsed since the camera was last turned on, turn it off and back on again)
9. Loop back to step (3), until batteries are exhausted and camera shuts down
The number of shots captured under the above conditions then becomes the CIPA battery-life figure.
Valami ilyesmit igazán bevezethetnének a mobiltelefonoknál is. Végre.[ előzmény: (53600) magpet, 2010.12.18 11:17:17] |